Instructions for Veneer Peeling Machine-Maintenance and lubrication

　It is necessary to maintain its performance and safety well and use it properly.All servicing,lubrication and cleaning of the machine must be carried out with the machine disconnected from the electric circuits.Do not carry our any work on live electrical equipment.Any derogation to this general rules must be authorized by the person in charge.Always carry out particularly dangerous operation at the presence of another person.

　Periodic lubrication

　To keep your machine all right,should lubricate as prescribed,before testing the machine,shall add lubricating oil or grease on the moving parts of guiding shaft,hanging wheel rack,clutch gear,idler wheel,etc.Within 40 hours when machine are new,add lubricating oil every 2 hours at guiding shaft,hanging wheel rack,clutch gear,idler wheel,etc.After 200 hours of working,lubricating twice every eight hours to lubrication parts.Every 200 hours of work:Check if all control buttons functioning well and single and double roller driven belts in abrasion or looseness.

　Adjust belt tension

　When belt is in slack,it may appear skidding,need the belt tension.

Main motor	add 12N powerto the midpoint of single belt	flexibility 15mm
Single roller motor	add 8N power to the midpoint of single belt	flexibility 8mm
Forward & backward motor	add 7N power to the midpoint of single belt	flexibility 10mm

　Change of rotary cut blade

　Rotary peeling blade needed to be replaced under following conditions:

　1.No smooth surface peels obtained

　2.Rotary peeling blade and cutting knife appears lose teeth or worn out

　Refer to replace of rotary peeling blade,please see Chapter 3.6 of“install rotary blade

　RECOMMENDED LUBRICATION

Guiding track oil（SH-T0361-1998）	arc slot, guiding shaft, chain wheel,hanging gear wheel, clutching gear
Lithium-base lubrication grease（GB491-1987）	Bearing seat,arc slot, big and small gears, rolling shaft